Living Room Fan Coil
The toughest job was lifting this equipment into place. It hung from threaded rods with vibration isolation brackets.
Then I connected the water piping. The main 1 1/2" copper medium temp water riser is on the left. It needs to be insulated.
.
Once that was done I had to piece in the ductwork. Most of it was custom sizes. The fan coil did not have standard fittings. The return duct connector changed size and had to be offset down and to the right.
I had to put together my own controls. The speed control on the top came with the unit. The box below has a relay and some terminal connections for the thermostat and stuff.
